Haas st40 turret alignment. May 22, 2023 · 1 With the turret set on spindle center line by using the co-axial indicator: Go into Debug mode by using your Haas Control Key. If the input does not change, refer to: Proximity Sensor - How it Works and Troubleshooting Guide Oct 9, 2025 · Then refer to ATP - Probe Replacement - AD0632 to see the replacement procedure. I have sent turret out and Haas sent me procedure to correctnever had displeasure of having to have rest of machine aligned Click to expand Re: HAAS ST30 Turret Alignment Procedure There is no alignment procedure, there is a tool change offset and grid offset to line the gears up so the turret can clamp properly. 2. 080 nub when facing. Oct 15, 2025 · If an input does not change, jump the cable connector on the turret connector bracket. Turret alignment to spindle was thought was to be rough aligned with face bolts then tweaked by jogging A axis. Refer to ST-10/10Y, SL-10-30, TL-15/25, HL-1-6 - Turret Lock and Unlocked Sensors - Adjustment procedure. The issue is that I can home all/zero return and all is Thread: NEED HELP: Haas ST-10 turret problems Thread Tools 02-17-2023, 09:48 AM #1 Doberman44. Use the arrow keys to navigate to Parameters then down to Factory. hrg ilkor pvjokn earrv zpq mbfdh rmzt sfeuk vumkvo pcc